|
|
|
![]() |
|||||||||||||||||||||||||||||||
Backup safety device install procedures
|
|||||||||||||||||||||||||||||||||
| Recommended tools | Install Video - 56K 100K 250K |
| Bumper types | Download manual - pdf word |
| Wiring | Brouchure - pdf |
Installation
Procedures
|
1.
Built-in Type (Open-Hole) |
|||||
|
|
To
Install this type of sensor, a hole must be drilled on the bumper. The
installation is permanent so the sensor may be painted to match with car rear
bumper color. This type of sensor is similar to the sensor of PORSCHE, BMW and
HONDA. The diameter of the hole is 22mm.
|
||||
|
|
|||||
|
1.1
|
Process to install built-in type
(open-hole) |
||||
|
|||||
|
1.2
|
Adjust the sensor angle |
||||
|
|||||
Download pdf brochure - Here
|
Parking-E is strictly a driver assistance device, and should not be relied upon as a substitute for safe driving practices. Use common sense when reversing, and always follow recommended safe driving guidelines from your local, State or County Department of Motor Vehicles regarding engagement of reverse gear. To help prevent accidents, always use caution when reversing, looking visually to ensure your path is clear. Keep reversing speeds under 5 mph. The owner shall not be entitled to recover from the Company, its successors or assignees, incidental and consequential damages, such as personal injury, loss of income, loss of time, loss of profits, loss of vehicle use or property damage. |